IVS Control Commands

These commands allow modification of the settings on the FileWave IVS (Imaging Virtual Server). These imaging-control commands require root authorization. 
 List of Imaging-Control  commands 
 imaging-control networksetup static

imaging-control networksetup dhcp

imaging-control subnet add

imaging-control subnet remove

imaging-control increase harddrive

imaging-control list macimages

imaging-control list windowsimages

imaging-control disable macimaging

imaging-control disable windowsimaging

imaging-control enable macimaging

imaging-control enable windowsimaging 
 Configuring the IVS network interface 
 The FileWave IVS network is configured to use dhcp by default. This command has 2 options: 
 imaging-control networksetup static 
 This command will prompt for static ip information and configure the network interface to it 
 
 imaging-control networksetup dhcp 
 This command will switch the IVS networking interface back to dhcp 
 
 Configuring subnets on the IVS 
 The FileWave IVS will default to listening only on the subnet that it’s ip address is from.  This command can be used to add subnets for the IVS to listen to or remove subnets: 
 imaging-control subnet add 
 This command will prompt for a valid ip address from the subnet and the subnet mask 
 
 imaging-control subnet remove 
 This command will display the subnets that the IVS is currently listening to and allow removal 
 
 Increasing the IVS hard drive 
 imaging-control increase harddrive 
 This command will allow the virtual disk on the IVS to be increased.  The default size is 250gb.  This command will require that the IVS is first shutdown and the hard drive is expanded in the vm settings. 
   
   
 
 Viewing list of images on IVS 
 These commands will list Mac and Windows images being hosted on the IVS currently 
 imaging-control list macimages 
 
 imaging-control list windowsimages 
 
 Configuring the IVS for Mac or Windows 
 The default settings on the IVS allow for Mac and Windows imaging.  These commands will allow you to disable/enable Mac or Windows imaging on the IVS. 
 imaging-control disable macimaging 
 This command disables Mac imaging on the IVS. 
 imaging-control disable windowsimaging 
 This command disables Windows imaging on the IVS. 
 imaging-control enable macimaging 
 This command enables Mac imaging on the IVS. (default setting) 
 imaging-control enable windowsimaging 
 This command enables Windows imaging on the IVS. (default setting)