Networking - Assign static IP Address for a FileWave Booster Appliance

For the Linux based Booster if you cannot use the port https://server:10000 to change network setting please follow the instructions below:

Debian Linux

Changing the IP address in Debian 12, which uses systemd-networkd for network management, involves different steps compared to CentOS. The following guide is tailored for Debian 12 servers using systemd-networkd but you could also use Webmin on your server assuming the server comes online initially with DHCP.

For Webmin know that you will need to go to Webmin -> Webmin Configuration -> Operating System and Environment and make sure it's set to Debian 12.4 (Or whatever version we are at when you set up your system. You can see this with cat /etc/debian_version on the server.

Locate Network Interface:

First, identify the network interface you wish to configure. You can list all network interfaces using:
```
networkctl list
```
Configure Network Settings:
systemd-networkd uses individual .network files for each network interface, located in /etc/systemd/network/.

Create or edit the network configuration file for your interface, named like 10-eth0.network (replace eth0 with your interface name).
```
sudo nano /etc/systemd/network/10-eth0.network
```
Configure IP Address:
In the .network file, add or modify the following sections:
```
[Match]
Name=eth0

[Network]
Address=192.168.1.100/24
Gateway=192.168.1.1
DNS=8.8.8.8
DNS=8.8.4.4
LinkLocalAddressing=no
IPv6AcceptRA=no
```
Replace eth0 with your actual network interface name.
Modify the Address with your new IP and subnet mask (e.g., /24 for a 255.255.255.0 netmask).
Set the Gateway and DNS entries as per your network configuration.

You'll also want to edit /etc/network/interfaces because ens192 is configured there for DHCP. That's how you might have gotten to it via Webmin for instance. Edit the file to put a # before the 2 lines that have ens192 on them. Those 2 lines in the file will look like this after editing:
```
# The primary network interface
#allow-hotplug ens192
#iface ens192 inet dhcp
```
Reload and Restart systemd-networkd:

After making changes, enable the Networkd service so interfaces come up at boot time, and reload the daemon and restart the network:
```
sudo systemctl enable systemd-networkd
sudo systemctl daemon-reload
sudo systemctl restart systemd-networkd
```
Verification:

Check the status of your network interface to ensure the new settings are active:
```
networkctl status eth0
```
You can also use ip addr show eth0 to view the IP configuration.

CentOS Linux

Depending if you are using the appliance we offer for a CentOS Linux virtual appliance or a Linux machine you built the steps may be slightly different. The steps shown below will be for the FileWave virtual appliance that we offer.

Configure the "ifcfg-ens160" file on the server. (This file will be different if you are not using our Virtual Appliance and will have a different name like "ifcfg-eth1" for example)
```
vi /etc/sysconfig/network-scripts/ifcfg-ens160
```
Change/add the following values of the file.
1. Change BOOTPROTO=none
2. Add "IPADDR", "NETMASK", "GATEWAY", "DNS1" to the file with your network configurations. I attached a screen shot of a completed file below. (If you want to add more then one DNS server you can add DNS2, etc to the file)
3. Save the file using "esc" then ":wq"
Now you will need to restart the network services on the server.
```
/etc/init.d/network restart
```